Can you paint corner bead

Any help will be much appreciated, thanks. Sharpey , 27 Feb The beading is galvanised so you can paint over it but as you've got some bin give it a quick coat as sometimes the paint can look darker over beading. For future ref it may be easier to just hold a straight edge against the corner as you fill. Thanks x 1. Thanks for your help Dcdec. Straight edge, didn't think of that! Joined: 3 Sep Country:. Select the supplier or trade you require, enter your location to begin your search. Please select a service and enter a location to continue You must log in or sign up to reply here.

I've never had an issue with that myself but I'm also not a professional sheetrocker Outside edge should be clearly visible considering that's plain of the wall,but just the rounded bead itself.

To float over it one might consider not even using a corner beings it will chip off the first time you sneeze. The fact is that first off, metal edged corner bead is rarely used by professionals. When it is used, it's most often due to imperfections with the drywall e.

I can't tell from that photo if that's an inside or outside corner. If it's an inside corner then the metal should have been covered. If it's an outside corner as I suspect , it can be very difficult to cover it with mud. As I said, it's rare to see these. One area where it's more likely though is with regards to ceilings, and particularly soffits - areas where uniformity of various drywall sheets is more likely to be an issue.

If this happens to you, I wouldn't sweat it. As long as your edges are sanded well, use a good quality primer and paint, and it won't matter.

You will not notice the difference. If in the future something gets damaged, the end result will be the same. A very thin layer of mud is not going to protect anything.

Put it this way: there is a reason for all that variety in the drywall aisle at Home Depot. Sign up to join this community. The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. Is it typical for the metal of corner bead to be exposed after it is finished being mudded? Ask Question. Asked 8 years, 11 months ago. Active 1 month ago.

When the first coat of joint compound is completely dry, check the surface for any protrusions and use the joint knife to scrape them off before proceeding. Apply a thick coat of joint compound over both side of the corner using crossing strokes with the joint knife. Work one side of the corner and then the other to apply a thick coat that covers the bead and spreads out onto the drywall. Immediately go back and skim off the excess mud to smooth it over the bead. Work on one wall at a time.

Clean the mud off the joint knife onto the side of the mud pan frequently to remove the buildup on the blade. When you finish, go back to the top and run the clean blade along the whole length of the corner in one smooth stroke. Scrape the mud from the peak of the corner bead using an upward stroke of the knife to finish the application.

Let the joint compound dry completely before proceeding. Apply a third coat of joint compound using a wider joint knife to smooth and level the corner. Use crossing strokes to coat both walls with a thick coat of mud and immediately go back over it to smooth it out.

Lightly skim off the excess mud using one complete stroke from top to bottom. Clean the mud off the joint knife at the end of the stroke. Do one wall and then the other. When you finish go back to the top and run the clean blade along the whole length of the corner again in one light, smooth stroke. Ask a tradesman. Like Like 9. Like 8. Like 4. Regards, Jonathan. Like 3. Like 1.